microHAM DXP Manual page 15

5.1 KB LAYOUT
defines layout of attached keyboard layout
•
QWERTY/QWERTZ/AZERTY
•
5.2 TYPE AHEAD
enables keyboard entry method
•
NO/YES
•
If set to YES, characters typed on keyboard are buffered and sent from the buffer only after a space key
is pressed. If set to NO, each character is sent instantly.
8.1 WK UPDATE
allow firmware updates for internal WinKey chip
•
NO/YES
•
If you would like to update the firmware of the internal WinKey chip, set this item to YES.
Run WK3Tools utility provided by K1EL and follow firmware update procedure described in WK3Tools
Guidebook. Once firmware is updated, click the Exit button in WK3Tools, return menu item 8.1 to NO,
and leave the menu. Disconnect and reconnect the USB cable to restart DXP; verify the correct WinKey
firmware version is displayed on DXP boot screen.
If you run the update without setting this menu item to YES, the update utility fails with a timeout. In that
case, WinKey needs to be reset first. To achieve that, disconnect and reconnect DXP to USB, and then
proceed as described above.
8.2 WK FSK
switches WinKey output from CW to FSK
•
NO/YES
•
If set to YES, DXP redirects WinKey KEY port to FSK output of DXP instead of CW. It allows use of the
new WinKey 3.1 FSK feature to send FSK from the chip in standalone mode.
9.1 Windows XP
switches between asynchronous or synchronous mode of audio data output
•
NO/YES
•
If you are using DXP on Windows XP, you must set this option to YES, otherwise audio output will not
work and you may experience BSOD. Windows XP did not support asynchronous (better) USB audio
downstreaming.
microHAM © 2019 All rights reserved
15