Lane Select; Pos Remote; Tx Power Setting - Panasonic Attune WX-C3010 Installation Instructions Manual

6.1.5 Lane Select

In the case of Double-Drive-Thru, one unit of Center Module is set for Lane A and Lane B, respectively. Only for the Center
Module of Lane B, the Dual Lane is set at ON. When Lane A or Lane B setup is changed over, the center module will be
restarted automatically.
If the [TALK] and [PAGE] indicators begin to blink after restarting, check the connections between both center modules.
Red: Lane A (Generally, this setting is used. This setting is default.)
Green: Lane B
Note: If lane setting is changed, ID registration should be reset.

6.1.6 POS Remote

This setting is made when the POS Remote function is used.
ON (Green): POS Remote Control is enabled. When ON is selected, the following button settings for the Center Module
become invalid:
SPEED TEAM
VEHICLE DETECTOR
BEEP DAY/NIGHT
OUTSIDE SP LEVEL DAY/NIGHT
TALK/PAGE RELEASE

6.1.7 TX Power Setting

The transmission power for the center module is set for maximum range.
If there is any radio interference with neighboring shops, set the transmit power to OFF.
ON (Green): Normal Power (Generally, this setting is used. This setting is default.)
OFF: Reduced Power (25%)