Yamaha Rhino 700 Fi Owner's Manual page 145

14. Insert the projections on the air filter case
cover into the holders on the air filter
case, and then install the air filter case
cover by hooking the holders onto the
cover.
1
1. Projection (× 2)
15. Install the air intake duct shroud by in-
stalling the quick fastener screws.
16. Close the hood.
2
2. Holder (× 2)
The air filter element should be cleaned every
20–40 hours. It should be cleaned and lubri-
cated more often if the vehicle is operated in
extremely dusty areas. Each time air filter ele-
ment maintenance is performed, check the air
inlet to the air filter case for obstructions.
Check the air filter element rubber joint to the
throttle body and manifold fittings for an air-
tight seal. Tighten all fittings securely to avoid
the possibility of unfiltered air entering the en-
gine.
NOTICE
Never operate the engine with the air filter
element removed. This will allow unfiltered
air to enter, causing rapid engine wear and
possible engine damage. Additionally, op-
eration without the air filter element will af-
fect the fuel
subsequent poor performance and possi-
ble engine overheating.
8-31
injection system with