Log Icons; Status Bar Icons - ABB Navigator 550 Operating Instructions Manual

Navigator 500
Hydrazine analyzer

6.10.3 Log icons

Source: wet-section 1 (red)
T1
S1 = sensor for wet-section 1
T1 = temperature for wet-section 1
Source wet-section 2 (green)
T2
S2 = sensor for wet-section 2
T2 = temperature for wet-section 2
Source wet-section 3 (blue)
T3
S3 = sensor for wet-section 3
T3 = temperature for wet-section 3
Source wet-section 4 (violet)
T1
S4 = sensor for wet-section 4
T4 = temperature for wet-section 4
Power failed / power failed
Configuration changed
System Error
File created / deleted
Media inserted / removed
Media on-line / off-line
Media full
Date / time or daylight saving start / end changed
High process alarm active / inactive
Low process alarm – active / inactive
High latch alarm – active / inactive
Low latch alarm – active / inactive
Alarm acknowledged
Table 6.7 Log icons
38

6.10.4 Status bar icons

Operator menu – displays the Operator menu when
the key is pressed.
Autoscroll – selected from the Operator menu
(displayed when Autoscroll enabled).
Indicates Operator pages are displayed sequentially.
Disabled if 1 Operator page only is configured for
display.
Calibration – shortcut access to the Calibration page
CAL
when the key is pressed.
Enter – selects the highlighted option from the
Operator menus when the
Service Level – indicates that alarms and analog
outputs are held.
Advanced Level – indicates that Advanced Level
parameters are enabled for the current user.
Calibrate Level – indicates that the Calibration Level
parameters are enabled for the current user.
Read Only Level – indicates that the transmitter is in
Read Only mode.
All parameters are locked and in cannot be
configured.
Table 6.8 Status bar icons
key is pressed.
OI/AHM550–EN Rev. A