Ordering Information - Siemens SIMODRIVE 611 Planning Manual

05.01
3.7

Ordering information

Order Nos. for the specified components, refer to the relevant Catalog
S
S
S
S
S
 Siemens AG 2001 All rights reserved
SIMODRIVE 611 Planning Guide (PJU) – 05.01 Edition
3 Motor Selection, Position/Speed Sensing
Pre–assembled encoder cables with
appropriate maximum permissible
cable lengths
SVE signal amplification
HGL module
Toothed wheel encoder and the
required diagnostics box
for adjustment
For drives with an analog speed setpoint interface, the encoder systems are
evaluated in the numerical control to sense the direct and indirect position.
When using Siemens controls, the encoder systems which can be evaluated
can be taken from the appropriate catalogs.
The same is true for the associated Order Nos. for the controls and measu-
ring circuit boards.
3.7 Ordering information
refer to Catalog NC Z
refer to Catalog NC 60
refer to Catalog NC 60
refer to Catalog NC Z
or NC 60
3
J
3-79