Suzuki SY413 Service Manual page 1797

1. Service wire
2. Diagnosis switch terminal
3. Ground terminal
4. DIAG-2 connector
5. DIAG-1 connector
DIAGNOSTIC TROUBLE CODE (DTC)
CLEARANCE
WARNING:
D When performing a road test, select a safe place where
there is neither any traffic accident possibility and be
very careful during testing to avoid occurrence of an ac-
cident.
D Road test should be carried out with 2 persons, a driver
and a tester, on a level road to avoid accident.
After repair or replace malfunction part(s), clear all DTC's by perform-
ing described procedure below.
1) Turn ignition switch OFF.
2) Using service wire, connect diag. switch terminal of DIAG-2
connector to ground terminal of DIAG-1 connector.
3) With connection described in above Step 2) maintained, turn
ignition switch ON.
4) Repeat on/off operation of service wire at diag. ground terminal
at least 5 times within 10 seconds.
NOTE:
Service wire ON time must be for 0.1 second and more.
5) Turn ignition switch OFF and disconnect service wire from
DIAG-2 connector.
6) Perform DRIVING TEST and DTC CHECK and confirm that
normal DTC (DTC 12) is displayed; not malfunction DTC.
NOTE:
It is also possible to clear DTC by using SUZUKI scan tool.
Refer to Cartridge Manual for procedure to clear DTC.
ANTILOCK BRAKE SYSTEM (ABS) 5B-13