Suzuki SY413 Service Manual page 2203

7B1-150 AUTOMATIC TRANSMISSION
1. Forward clutch
2. Gasket
1. Transmission rear cover
2. Engine mounting LH bracket
1. Integrated needle
roller bearing
1. Parking lock pawl
2. Parking lock rod
3. Parking lock pawl bracket
42) Apply sealant to contacting surface of transmission case by
43) Install five gaskets.
3. Nozzle
44) Tighten transmission rear cover and engine mounting LH
45) Turn over transmission.
46) Remove transmission housing.
47) Remove oil pump body, 1st and reverse clutch and 2nd and 4th
48) Apply A/T fluid to race with integrated needle roller bearing.
49) Install counter driven gear.
50) Install parking lock rod with parking lock pawl, parking lock
51) With spacer and torsion spring placed, install bolt and tighten
4. Manual valve bracket
52) Insert parking lock rod to parking lock pawl bracket and con-
5. Spring
using a nozzle as shown in figure by such amount that its sec-
tion is 1.5 mm (0.059 in) in diameter.
"A": Sealant 99000-31230 (SUZUKI BOND NO.1216B)
NOTE:
There is no installation direction for new gaskets.
bracket with ten (two new bolts (1)) bolts.
Tightening Torque
(a): 25 N·m (2.5 kg-m, 18.0 Ib-ft)
brake band from transmission case.
Race dimension
Outside diameter : Approximately 65.8 mm (2.59 in.)
Inside diameter : Approximately 51.0 mm (2.01 in.)
Thickness : Approximately 2.7 mm (0.11 in.)
pawl bracket and torsion spring.
parking lock pawl bracket.
Tightening Torque
(a): 10 N·m (1.0 kg-m, 7.5 Ib-ft)
nect parking lock rod with manual valve lever.