Suzuki SY413 Service Manual page 1669

4-6 FRONT DRIVE SHAFT
INSPECTION
D Check boots for breakage or deterioration. Replace them as
necessary.
D Check circlip, snap ring and boot bands for breakage or de-
formation. Replace as necessary.
DISASSEMBLY (Center Shaft and
Center Bearing Support)
[1.3 L and 1.6 L Engine Models]
1) Remove right side oil seal from center bearing support.
2) Remove circlip.
1. Center bearing support
3) By using hydraulic press, draw out center shaft from center
1. Press
2. Center shaft
3. Center bearing support
4) Remove left side oil seal from center bearing support.
5) Remove bearing support circlip.
6) Remove center bearing from center bearing support.
1. Circlip
[1.8 L Engine Model]
1. Press
2. Center shaft
3. Center bearing support
1) By using hydraulic press, draw out center shaft from center bear-
2) Remove oil seals from center bearing support.
Special Tool
(A): 09900-06107
bearing.
ing.