Suzuki SY413 Service Manual page 1542

3C-12 STEERING WHEEL AND COLUMN (NOT EQUIPPED WITH AIR BAG)
1. Steering joint lower cover
2. Steering shaft upper joint bolt
1. Steering joint lower cover
2. Steering shaft upper joint bolt
3. Steering joint upper cover
1. Junction/fuse block
1. Junction/fuse block
1. Hole cover
5) Install bolt to steering shaft upper joint and tighten it to speci-
fied torque.
NOTE:
After tightening column nuts, bolt to steering shaft upper
joint should be tightened.
Tightening Torque
(c): 25 N·m (2.5 kg-m, 18.0 lb-ft)
6) Install steering joint upper cover.
7) Connect three connectors for ignition switch wire harness from
junction/fuse block.
8) If combination switch is removed, install combination switch.
Refer to "COMBINATION SWITCH" earlier in this section.
9) If combination switch is not removed, follow the procedures
below.
D Connect three connectors for combination switch wire har-
ness to junction/fuse block.
D Disconnect white 4-P connector (for auto cruise, optional).
D Fix wire harness with clamp and band.
10) Install hole cover.
11) If steering wheel is removed, install steering wheel. Refer to
"STEERING WHEEL" earlier in this section.
12) Connect negative battery cable.