Dell PowerEdge M605 Hardware Owner's Manual page 69

Table 1-18. Blade Messages (continued)
Message
DIMMs must be
populated in
sequential order
beginning with
slot 1. The
following DIMM is
electrically
isolated: DIMM x .
DIMM pairs must be
matched in size,
speed, and
technology. The
following DIMM
pair is
mismatched: DIMM x
and DIMM y.
Diskette read
failure.
Drive not ready.
Error: Incorrect
memory
configuration.
DIMMs must be
installed in pairs
of matched memory
size, speed, and
technology.
Error: Incorrect
memory
configuration.
System halted.
Causes
The specified DIMM is
inaccessible to the system
due to its location.
DIMMs must be
populated in sequential
order, beginning with
slot 1.
Mismatched or
unmatched DIMMs
installed; faulty or
improperly seated memory
modules.
Faulty or improperly
inserted diskette.
Diskette missing or
improperly inserted in
diskette drive.
Mismatched or
unmatched DIMMs
installed; faulty or
improperly seated memory
modules.
Less than 512 MB of
memory installed.
Corrective Actions
Populate two, four, or eight
DIMMs sequentially.
Ensure that all pairs of
memory modules are of the
same type and size, and that
they are properly installed.
See "System Memory" on
page 105. See
"Troubleshooting Blade
Memory" on page 191.
Replace the diskette.
Reinsert or replace the
diskette.
Ensure that all pairs of
memory modules are of the
same type and size, and that
they are properly installed.
See "System Memory" on
page 105. If the problem
persists, see
"Troubleshooting Blade
Memory" on page 191.
Add memory modules to
achieve a configuration
supported by the system.
See "System Memory" on
page 105.
About Your System
69