Figure 4-9. Removing and Installing the Midplane
1
front module cage assembly
3
screws (4)
Installing the Midplane and Front Module Cage Assembly
CAUTION:
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1 Attach the midplane to the front module cage assembly and secure it with
the four Torx screws. See Figure 4-8.
2 Connect the control-panel cable to the midplane.
3 Carefully slide the front module cage assembly into the enclosure. See
Figure 4-9.
4 Install the four screws to secure the front module cage assembly.
5 Install the I/O modules. See "Installing an I/O Module" on page 167.
172
Installing Enclosure Components
1
Only trained service technicians are authorized to remove the system
2
2
midplane
3