Disabling A Forgotten Password - Dell PowerEdge M605 Hardware Owner's Manual

Table 7-8. PowerEdge M605 System Board Connectors (continued)
Connector
12 BATTERY
13 J_STORAGE
14 B1
15 B2
16 B3
17 B4
18 J_VIDEO
NOTE:
For the full name of an abbreviation or acronym used in this table, see the
"Glossary" on page 219.

Disabling a Forgotten Password

The blade's software security features include a system password and a setup
password, which are discussed in detail in "Using the System Setup Program"
on page 79. The password jumper enables these password features or disables
them and clears any password(s) currently in use.
CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Remove the blade. See "Removing a Blade" on page 96.
2 Open the blade. See "Opening the Blade" on page 100.
3 If you are changing the jumper setting on a PowerEdge M905 or M805
blade, remove the system board to gain access to the jumpers. See
"Removing the System Board" on page 150.
4 Relocate the jumper plug to disable the password feature.
See Figure 7-1 (PowerEdge M905), Figure 7-2 (PowerEdge M805),
Figure 7-3 (PowerEdge M600), or Figure 7-4 (PowerEdge M605) to locate
the password jumper on the blade board.
214
System Board Information
Description
Connector for the 3.0-V coin battery
Storage controller card connector
Memory module connector, slot B1
Memory module connector, slot B2
Memory module connector, slot B3
Memory module connector, slot B4
Video controller card connector
Many repairs may only be done by a certified service technician. You