5.2.2
Configuration
Please connect PC and HUB, HUB and EH-ETH with LAN cable (10BASE-T).
The example in Figure5.2.2 shows the smallest network by the explanation of for convenience.
PC
5.2.3
Network Setting on PC side
You can not access to web setup page of EH-ETH immediately without following setting for the PC.
At the network configuration of figure 5.2.2, to access set up web page of EH-ETH, the setting of PC must be
the below condition.
1). Subnet mask is 255.255.255.0.
2). IP address's upper 3 byte is 192.168.0 and lower byte is not duplicated the EH-ETH IP address lowest
byte.
*1: EH-ETH IP address lowest byte is set by dipswitch 3 to 8.
Tentatively, in case of subnet mask is 255.255.255.0 at PC side, and IP address is 192.168.0.128,
you do not need to set network setting at PC side. (Recommended value)
On the other hand, in case of subnet mask is 255.255.0.0, and IP address is 172.16.0.128,
you need to change the network setting on PC.
Chapter 5 Configuration and procedure for starting communication
HUB
Figure 5.2.2 Example of network
5-3
PLC / EH-ETH