2Installing The Accessories; Installing The Accessories - Canon Finisher-R1 Service Manual

Chapter 3
<Finisher-R1>
[1]Inlet guide upper
[2]Inlet guide lower
[3]Fixing plate (FC5-4196)
[5]Staple cartridge
[7]Front foot cover
[9]Rail
[10]Cable clamp
[11]Screw (RS tightening; M3x8)
[12]Screw (tapping; M4x12)
[13]Screw (binding; M4x6)
[14]Screw (stepped; M4)
[15]Tray label
[16]Settings label

3.1.2 Installing the Accessories

If you are installing the machine and other accessories at the same time, install the host machine, and then install the
accessories in the following order:
1.Side paper deck (see its Installation Procedure)
2.Finisher [1], [2] (See "Preparing the Finisher for Installation" herein)
3.Additional finisher tray [3] (see its Installation Procedure)
4.Puncher unit [4] (see its Installation Procedure)
5.Connection with the host machine (See the instructions herein or "Connecting to the Host Machine" in the
"Puncher Unit Installation Procedure")
3-2
T-3-1
<Saddle Finisher-R2>
1 pc. [1]Inlet guide upper
1 pc. [2]Inlet guide lower
2 pc. [3]Fixing plate (FC5-4196)
1 pc. (3 blocks) [4]Fixing plate (FC5-4976)
1 pc. [5]Staple cartridge
1 pc. [6]Saddle staple cartridge
1 pc. [7]Front foot cover
1 pc. [8]Rear foot cover
2 pc. [9]Rail
6 pc. [10]Cable clamp
2 pc. [11]Screw (RS tightening; M3x8)
1 pc. [12]Screw (tapping; M4x12)
1 pc. [13]Screw (binding; M4x6)
[14]Screw (stepped; M4)
[15]Tray label
[16]Settings label
[17]Bookmaking label
1 pc.
1 pc.
1 pc.
1 pc.
1 pc. (3 blocks)
1 pc. (2 blocks)
1 pc.
1 pc.
1 pc.
1 pc.
1 pc.
3 pc.
6 pc.
2 pc.
1 pc.
1 pc.
1 pc.
0003-1756