Samsung SC-M102 Owner's Instruction Book page 3

ENGLISH
Notices and Safety Instructions
14. LIGHTNING:
For added protection of the CAM during a lightning
storm or when it is left unattended and unused for long periods of
time, unplug it from the wall outlet and disconnect the antenna or
cable system.
This will prevent damage to the CAM due to lightning and
power-line surges.
15. POWER LINES:
An outside antenna system should not be located in the vicinity of
overhead power lines or other electric light or power circuits where it can
fall into such power lines or circuits. When installing an outside antenna
system, extreme care should be taken to keep from touching such power
lines or circuits as contact with them might be fatal.
16. OVERLOADING
Do not overload wall outlets and extension cords as this can result in a
risk of fire or electric shock.
17. OBJECTS AND LIQUIDS:
Never push objects of any kind into the CAM through openings as they
may touch dangerous voltage points or short out a part that could result
in a fire or electric shock.
Never spill liquids of any kind onto the CAM. Should spillage occur,
unplug unit and have it checked by a technician before use.
18. SERVICING:
Do not attempt to service the CAM yourself.
Opening or removing covers may expose you to dangerous voltage or
other hazards.
Refer all servicing to qualified service personnel.
19. DAMAGE REQUIRING SERVICE:
Unplug the CAM from the wall outlet and refer servicing to qualified
service personnel under the following conditions:
When the power-supply cord or plug is damaged.
If any liquid has been spilled onto, or objects have fallen into the CAM.
If the CAM has been exposed to rain or water.
If the CAM does not operate normally by following the operating
instructions, adjust only those controls that are covered by thee
operating instructions. Improper adjustment of other controls may
result in damage and will often require extensive work by a qualified
technician to restore the CAM to its normal operation.
If the CAM has been dropped or the cabinet has been damaged.
When the CAM exhibits a distinct change in performance, this indicates
a need for service.
20. REPLACEMENT PARTS:
When replacement parts are required, be sure the service technician has
used replacement parts specified by the manufacturer and having the
same characteristics as the original part.
Unauthorized substitutions may result in fire, electric shock or other
hazards.
21. SAFETY CHECK:
Upon completion of any service or repairs to the CAM, ask the service
technician to perform safety checks to determine that the CAM is in
safe operating order.
To prevent damage which may result in fire or shock hazard,
do not expose this appliance to rain or moisture.
Notices and Safety Instructions
21. POWER SUPPLY
If this power supply is used at 240V AC, a suitable plug adapter should
be used.
NOTE TO CATV SYSTEM INSTALLER:
This reminder is provided to call the CATV system installer's attention to
Article 820-40 of the NEC that provides guidelines for proper grounding and,
in particular, specifies that the cable ground shall be connected to the
grounding system of the building as close to the point of cable entry as
practical.
USER INSTALLER CAUTION:
Your authority to operate this FCC certified equipment could be voided if you
make changes or modifications not expressly approved by this party
responsible for compliance to part 15 FCC rules.
NOTE:
Hg LAMP(S) INSIDE THIS PRODUCT CONTAIN
MERCURY AND MUST BE RECYCLED OR DISPOSED
OF ACCORDING TO LOCAL, STATE OR FEDERAL LAWS.
For details see lamprecycle.org, eiae.org, or call 1-800-Samsung.
ENGLISH
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help and for
additional suggestions.
The user may find the following booklet prepared by the Federal
Communications Commission helpful: "How to Identify and Resolve Radio-TV
Interference Problems."
This booklet is available from the U.S. Government Printing Office,
Washington, D.C. 20402, Stock No. 004-000-00345-4.
FCC Warning
The user is cautioned that changes or modifications not expressly approved by
the manufacturer could void the user's authority to operate the equipment.
FCC ID: A3L04SPIDER
This device complies with Part 15 of FCC Rules.
Operations is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference
that may cause undesired operation.