Samsung SC-M102 Owner's Instruction Book page 2

ENGLISH
Notices and Safety Precautions
Notices and Safety Instructions
CAUTION
RISK OF ELECTRIC
SHOCK
DO NOT OPEN
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
To prevent electric shock, match wide blade of plug to
wide slot and fully insert.
1.READ INSTRUCTIONS:
All the safety and operating instructions should be read before the CAM is
operated.
2.RETAIN INSTRUCTIONS:
The safety and operating instructions should be retained for future
reference.
3.HEED WARNINGS:
All warnings on the CAM and in the operating instructions should be
adhered to.
4.FOLLOW INSTRUCTIONS:
All operating and maintenance instructions should be followed.
5.CLEANING:
Unplug this the CAM from the wall outlet before cleaning. Do not use liquid
or aerosol cleaners. Use a dry cloth used for dusting cabinets.
6.ATTACHMENTS:
Do not use attachments not recommended by the CAM product
manufacturer as they may be hazardous.
This symbol is intended to alert the user to the presence of uninsulated
dangerous voltage within the product s enclosure that may be of
sufficient magnitude to constitute a risk of fire or electric shock.
This symbol is intended to alert the user to the presence of important
operating and maintenance instructions in the literature accompanying
this product.
7.WATER AND MOISTURE.
Do not use the CAM near water;
for example, near a bathtub, wash bowl, kitchen sink, laundry tub, in a wet
basement, near a swimming pool or lake.
8. ACCESSORIES:
Do not place the CAM on an unstable cart, stand, tripod, bracket or table.
the CAM may fall, causing serious injury to a child or adult, and serious
damage to the unit.
Use only with a cart, stand, tripod, bracket, or table recommended by the
manufacturer or sold with the CAM. Any mounting of the unit should follow
the manufacturer s instructions and should use a mounting accessory
recommended by the manufacturer.
An appliance and cart combination should be moved with care.
Quick stops, excessive force and uneven surfaces may cause the
appliance and cart combination to overturn.
PORTABLE CART WARNING (Symbol provided by RETAC)
Notices and Safety Instructions
9. VENTILATION:
Slots and openings in the cabinet are provided for ventilation to ensure
reliable operation of the CAM and to protect it from overheating. These
openings must not be blocked or covered. Never place your the CAM on
a bed, sofa, rug, or other similar surface: on or near a radiator or heat
register. The CAM should not be placed in a built-in installation such as a
bookcase or rack unless proper ventilation is provided or the
manufacturer s instructions have been adhered to.
10. POWER SOURCES:
The CAM should be operated only from the type of power source
indicated on the label.
If you are not sure of the type of power supply at your home, consult your
appliance dealer or local power company.
If the CAM is intended to be operated from battery power, or other
sources, refer to the operating instructions.
11. GROUNDING OR POLARIZATION:
The CAM may be equipped with either a polarized
2-wire AC line plug (a plug having one blade wider than the other)
or a 3-wire grounding type plug, a plug having a third (grounding) pin.
If you are unable to insert the plug fully into the outlet, try reversing the
plug. If the plug still fails to fit, contact your electrician to replace your
outlet. Do not defeat the safety purpose of the polarized plug.
12. POWER-CORD PROTECTION:
Power-supply cords should be routed so that they are not likely to be
walked on or pinched by items placed upon or against them, playing
particular attention to cords or plugs, convenient receptacles, and the
point where they exit from the unit.
ENGLISH
13. OUTDOOR ANTENNA GROUNDING:
If an outside antenna or cable system is connected to the CAM, be sure
the antenna or cable system is grounded to provide some protection
against voltage surges and built-up static charges, Section 810 of the
National Electrical Code, ANSI/NFPA No. 70-1984, provides information
with respect to proper grounding of the mast and supporting structure,
grounding of the lead-in wire and supporting structure, grounding of the
mast and supporting structure, grounding of the lead-in wire to an
antenna discharge unit, size of grounding to conductors, location of
antenna-discharge unit, connection to grounding electrodes and
requirements for the grounding electrode.
See figure below.
ANTENNA
LEAD IN WIRE
GROUND
CLAMP
ANTENNA
DASCHARGE UNIT
(NEC SECTION 810-20)
ELECTRIC SERVICE GROUNDING CONDUCTORS
(NEC SECTION 810-21)
EQUIPMENT
GROUND CLAMPS
POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H)
NEC NATIONAL ELECTRICAL CODE