Potentiometer - Siemens SITOP PSU100C 6EP1321-5BA00 Operating Instructions Manual

2.3

Potentiometer

The potentiometer
output voltage is set to the rated value at the factory and can be set within certain limits; for
example, to compensate voltage drops across long supply lines to the connected load.
Figure 2-3
Type
6EP1321-5BA00 (12 V/2 A)
6EP1322-5BA10 (12 V/6.5 A)
6EP1331-5BA10 (24 V/1.3 A)
6EP1332-5BA00 (24 V/2.5 A)
6EP1332-5BA10 (24 V/4 A)
6EP1331-5BA00 (24 V/0.6 A)
6EP1332-5BA20 (24 V/3.7 A)
The following devices do not have a potentiometer: 6EP1331-5BA00 and 6EP1332-5BA20.
NOTICE
Thermal overload possible
When adjusting the output voltage to >24 V or >12 V, the output current must be derated by
4%/V.
Note
It is only permissible to activate the potentiometer using an insulated screwdriver.
For notes on actuating the potentiometer (screwdriver, torque), see Figure 2-2 Terminal data
(Page 10).
SITOP PSU100C
Operating Instructions, 06.2013, C98130-A7599-A1-2-7629
④
on the front of the device is used to adjust the output voltage. The
Potentiometer (example 6EP1332-5BA10)
Factory setting
12 V
24 V
24 V
Description, device design, dimension drawing
Setting range
10.5...12.9 V
22.2...26.4 V
-
2.3 Potentiometer
11