Table of Contents
Advertisement
RUGGEDCOM ROX II
CLI User Guide
Section 2.5.5
Tracing the Route of an IPv4 Address Using MPLS Protocols
To trace the route of an IPv4 address using MPLS protocols, type:
mpls-traceroute remoteIPAddr/Pre
Where:
• remoteIPAddr/Pre is the IPv4 address of the MPLS trace route
Section 2.5.6
Tracing Activities on a Serial Port
To trace activities on a serial port, type:
traceserial [ port slot port | hex | protocol | tcp-udp ]
Where:
• port slot port defines the port to trace
• hex displays the content of serial data in a hex
• protocol traces the serial protocol on the serial port
• tcp-udp traces TCP-UDP events on the serial port
Section 2.6
Using the Command Line Interface
The following sections describe how use the Command Line Interface (CLI):
•
Section 2.6.1, "Accessing Different CLI Modes"
•
Section 2.6.2, "Using Command Line Completion"
•
Section 2.6.3, "Displaying Available Commands"
•
Section 2.6.4, "Editing Commands"
•
Section 2.6.5, "Using Output Redirects"
•
Section 2.6.6, "Using Regular Expressions"
•
Section 2.6.7, "Using CLI Utilities"
•
Section 2.6.8, "Specifying a Range"
•
Section 2.6.9, "Common Commands"
Section 2.6.1
Accessing Different CLI Modes
RUGGEDCOM ROX II provides commands for monitoring and configuring software, hardware and network
connectivity. The Command Line Interface (CLI) supports the following modes:
Tracing the Route of an IPv4 Address Using MPLS
Protocols
Chapter 2
Using RUGGEDCOM ROX II
21
Advertisement
Table of Contents
Troubleshooting
