Adding A Route Map Filter Entry; Deleting A Route Map Filter - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
1. Make sure the CLI is in Configuration mode.
2. Add the new filter by typing:
routing bgp filter route-map tag
Where:
• tag is the tag for the route map filter
3. Add one or more entries. For more information, refer to
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.19.3.4

Adding a Route Map Filter Entry

To add an entry for an route map filter, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the new filter by typing:
routing bgp filter route-map tag entry number
Where:
• tag is the tag for the route map filter
• number is the sequence number for the entry
3. Configure the following parameter(s) as required:
Parameter
action { action }
call { call }
on-match-goto { on-match-goto }
4. Configure the match rules for the route map filter. For more information, refer to
"Configuring Match
5. Configure a set for the route map filter. For more information, refer to
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
6.
Section 5.19.3.5

Deleting a Route Map Filter

To delete a route map filter for dynamic BGP routes, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the filter key by typing:
no routing bgp filter route-map tag
Where:
Adding a Route Map Filter Entry
Rules".
Section 5.19.3.4, "Adding a Route Map Filter
Description
Synopsis: { deny, permit }
Default: permit
Action.
Jump to another route-map after match+set.
Go to this entry on match.
Section 5.19.3.8, "Configuring a
Chapter 5
Setup and Configuration
Entry".
Section 5.19.3.7,
Set".
319