Support-Mounted Installation - Huawei SUN2000 User Manual

SUN2000-(3.8KTL-11.4KTL)-USL0
User Manual
Procedure
Step 1 Determine the positions for drilling holes using the marking-off template. Level the positions
of mounting holes using a level, and mark the positions with a marker.
Step 2 Install tightening screws.
Avoid drilling holes into the utility pipes and/or cables attached to the back of the wall.
Step 3 Secure the mounting bracket.
Figure 4-8 Wall-mounted installation
(1) Frame post
----End

4.4.2 Support-Mounted Installation

Prerequisites
Prepare M6 stainless bolt assemblies (including flat washers, spring washers, and M6 bolts)
with appropriate lengths as well as matched flat washers and nuts based on the support
specifications.
Issue 01 (2018-05-21)
The example used in this document describes a frame post installation of the SUN2000.
If the wall uses a frame structure, tightening screws need to be installed at the frame post. Use a stud
finder to find the frame post behind the wall panel.
(2) Wall panel
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
(3) Bottom alignment line for the mounting bracket (top)
4 System Installation
27