Fujitsu ETERNUS DX60 S3 User Manual page 414

Appendix B
Error Code
The error codes for copy sessions are described below.
Error code
0x10 – 0x1F
0x20 – 0x2F
0x30 – 0x3F
0xB1
0xBA
0xBB
0xBD
0xBE
0xBF
Other than above
An error that is caused by a copy source volume occurs.
Some copy source volumes cannot be accessed because a failure has occurred in a compo-
nent (e.g. drives and drive enclosures).
An error that is caused by a copy destination volume occurs.
Some copy destination volumes cannot be accessed because a failure has occurred in a
component (e.g. drives and drive enclosures).
An error that is caused by a copy path occurs or an REC Buffer Halt occurs.
The error location (Suspected Spot) is displayed in the "Detail Information" field on the [Copy
Path] screen. Refer to "8.7.2 Copy Path" (page 385)
This copy session stopped due to an error that has occurred in the cascade source session
while the cascade copy was being specified.
A bad sector is detected.
SDV/SDP capacity is insufficient.
Overload status is detected in a copy destination volume or a copy destination storage
system.
A copy path error occurs. Data is stored in the REC Buffer.
This error is displayed only when the "Type" is "REC".
A copy path error occurs. Data is stored in the REC Disk Buffer.
This error is displayed only when the "Type" is "REC".
An error other than the ones listed above occurs.
414
ETERNUS Web GUI User's Guide (Operation)
Copyright 2016 FUJITSU LIMITED
Description
for details.
P2X0-1260-19ENZ0