Fujitsu ETERNUS DX60 S3 User Manual page 261

Chapter 5 Connectivity Status
5.3 CA Port Group
• Type
The type of the target port is displayed.
- 1G iSCSI
1Gbit/s iSCSI. The port mode can be changed (CA, RA, or CA/RA).
- 10G iSCSI
10Gbit/s iSCSI. The port mode can be changed (CA, RA, or CA/RA).
- 10G Base-T iSCSI
10Gbit/s iSCSI. The port mode can be changed (CA, RA, or CA/RA). This port can be installed in the
ETERNUS DX60 S3, the ETERNUS DX100 S3/DX200 S3, and the ETERNUS AF250.
• Status
The status of the target port is displayed.
• Port Mode
The mode of the target port is displayed.
- CA
- RA
- CA/RA
• Multiple VLAN
Whether the Multiple VLAN is enabled or disabled for the target port is displayed. "Multiple VLAN" is a func-
tion that enables up to 16 pieces of VLAN information (IP address information) to be registered for each
port.
A "-" (hyphen) is displayed when the port mode is "RA".
• Number of IP Addresses
The number of IP addresses that are used for the relevant port is displayed. When "Multiple VLAN" is
enabled, the number of IP addresses that are registered in the port is displayed. When "Multiple VLAN" is
disabled or "-" is displayed in the "Multiple VLAN" field, "1" is displayed.
• Transfer Rate
The transfer speed of the target port is displayed. All transfers are full-duplex.
- Auto-negotiation
- 1Gbit/s
- 10Gbit/s
- 100Mbit/s
• Reset Scope
The reset scope of the target port is displayed.
Reset scope is the range where the command reset from the server is performed, when the target port is
connected to multiple servers. A "-" (hyphen) is displayed when the port mode is "RA".
- I_T_L (I: Initiator, T: Target, L: LUN)
Reset (cancel) the command request from the server that sent the command reset request.
- T_L (T: Target, L: LUN)
Reset (cancels) the command request from all of the servers that are connected to the port.
• Release Reservation if Chip is Reset
Whether the function to release the reservation status of the volume when the target port (chip) is reset is
enabled or disabled is displayed.
A "-" (hyphen) is displayed when the port mode is "RA".
• iSCSI Name
The iSCSI name of the target port is displayed.
261
ETERNUS Web GUI User's Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0