Connecting Power And Data Cables; Figure 4 Data Port Connection; Table 5 Wired Client Scenarios - ABB MicrOS 410 Installation Manual

Table of Contents

Connecting Power and Data Cables

The MicrOS 410 supports wired clients connected to either or both Ethernet or serial interfaces.

The MicrOS 410 is equipped with two RJ-45 connectors that are used for Ethernet and serial

interfaces and for powering the MicrOS 410 through the use of watertight glands.

Figure 4

Determine whether you have a MicrOS 410 with two Ethernet ports or one Ethernet port and one

serial port (see

Depending on the specific application, the use of one or both connectors may be required.

If you have a MicrOS 410 equipped with two Ethernet ports, either or both ports can be used for

Ethernet clients. Power must be applied on port 1.

Table 5

interfaces.

Table 5

Wired Client Scenario

One Ethernet client

One RS-232 serial client

One Ethernet client

Two RS-232 serial clients

One Ethernet client

One RS-485 serial client

One Ethernet client

One RS-232 serial client

One RS-485 serial client

MicrOS 410 Installation Guide

Data Port Connection

Table

1).

describes the possible wired client scenarios for a MicrOS 410 equipped with serial

Wired Client Scenarios

Recommended wiring

• Connect the Ethernet client to Port 1 (Ethernet) on the MicrOS 410