Chapter 4 Using Link; Connecting To A Telephone System - Samsung Version 2.1 User Manual

Message Monitoring
--------------------------------------------------------------------------------------------------------------------------------------------------------------------

Chapter 4 Using Link

Check the configuration of the Phone System.
Before connecting to the telephone system, you have to set up the connection parameters
within the system; the method used depends on the connection mode. (SIM, Serial, or
TCP/IP).
Telephone settings for a serial Link connection
For SIM or Serial connection mode,
Be sure that the MMC 804 settings of DCS Key telephone PBX system are as follows:
Sys IOPort
Service
BAUD RATE
CHAR LENGTH
PARITY
STOP BIT
RETRY COUNT
WAIT TIME
Note
The "*" means that you can change the value as needed.
The change of (1) entry depends on the number of ports provided by Samsung Key telephone
system.
The (2) entry can have one of CTI, CTI-SMDR, CTI/UCD, and CTI/S/U.
The baud rate of (3) entry depends on that of Samsung Key telephone system. The baud rate of
Link shall be specified based on the value of (3) entry.
Telephone settings for an IP Link connection
For TCP/IP connections,
Be sure that the IP address of the telephone system has been specified in the MMC
830. This IP address shall be the same as in the communication environment of Link.
Note
Some of the DCS Key telephone systems that support TCP/IP connections cannot transfer SMCR
/ UCD information to the TCP/IP port. When interworking with these systems, the Link does not
transfer the SMDR / UCD message.

Connecting to a telephone system

After setting the parameters above, click on the [CONNECT] button of Link
【 】, and proceed to the connection process of PBX system.
Note
In you intend to use the Link in the user management mode, add the user information before
proceeding to the connection process of PBX system. For details of user management, see later in
this chapter.
© SAMSUNG Electronics Co., Ltd.
OfficeServ Link Version 2.1 User Guide
2 * (1)
CTI-SMDR * (2)
9600 or 19200 * (3)
8
NONE
1
5
03000 msec.
Page 31