Table of Contents
Advertisement
5.2e Mounting Transducers into the UCF (cont.)
4. Place the transducers into the blocks. Make sure the junction box faces away from the block as shown below.
Note: If the transducer cables are already connected, you must determine the upstream and downstream directions of
the pipe and place the transducers into the appropriate blocks.
Flow
Top View
5. Use the pressure bolt to secure the transducer in place. The pressure bolt should fit into the dimple. Hand-tighten
enough to hold the transducer in place. Do not overtighten so that the fixture lifts off the pipe.
CAUTION FOR ATEX CERTIFIED INSTALLATIONS
To ensure against impact to the transducer face, it must always be mounted flush to the pipe.
Pressure Bolt
Top View
C-PT Ultrasonic Flow Transducer Installation Guide
17
Advertisement
Table of Contents
