GE C-PT Installation Manual page 22

5.2d The Single-Traverse Method -UCF (cont.)
10. Position the clamping fixture rails so that one of the short blocks is placed over the remaining crossmark on the
opposite side of the pipe and the pressure bolt is over the center of the crossmark. Make sure the block does not lie
on top of the chains of the long block.
11. Wrap the chain around the pipe and fasten the chain to the screw hook on the opposite side of the block. Do this for
both short blocks.
Note: Make sure the chains on both blocks are on the same side of the fixture and are opposite the ruler.
12. Tighten the pressure bolt all the way down on the short block that is NOT positioned over the crossmark. This will
act as a reminder to not install the transducer in that block.
14
Crossmark
Crossmark
Crossmark Crossmark
Short Block
Short Block
(one of two)
(One of two)
Top View
Top View
Top View
C-PT Ultrasonic Flow Transducer Installation Guide