GE C-PT Installation Manual page 17

5.2c The Double-Traverse Method -UCF (cont.)
5. Position the clamping fixture along the horizontal plane of the pipe, but not on the top or bottom. Make sure the
chains on both blocks are on the same side of the fixture and are opposite the ruler.
6. Wrap the chain around the pipe and fasten the chain on the J screw hook on the opposite side of the block. Do this
for both blocks.
7. Using the screw hook on the blocks, tighten the chains until the fixture is secured snugly to the side of the pipe.
Note: Make sure the chains are perpendicular to the clamping fixture and are not twisted. If the chains are slanted,
the slack may cause the fixture to move around. The slack may also change the transducer spacing after the
transducers are mounted.
C-PT Ultrasonic Flow Transducer Installation Guide
Side View
Top View
9