Table of Contents
Advertisement
5.2d The Single-Traverse Method - UCF (cont.)
13. Use the screw hooks to tighten the chains on the fixed and adjustable blocks until the blocks are secured snugly to
the pipe.
Note: Make sure both chains are perpendicular to the clamping fixture and are not twisted. If the chains are slanted,
the slack will cause the blocks to slide. The slack may also change the transducer spacing after the transducers
are mounted.
Figure 5 shows a completed single-traverse installation without transducers. Proceed to Mounting Transducers into the
UCF on page 16.
Figure 5: Single-Traverse Clamping Fixture Installation without Transducers
C-PT Ultrasonic Flow Transducer Installation Guide
Side View
S
Top View
15
Advertisement
Table of Contents
