GE IC695CNM001 Quick Start Manual page 9

Shield to
connector
CANopen Cable
The cable shield should be connected to each device on the
network.
Network Data Rates and Bus Lengths
The CNM001 module supports the estimated bus lengths and data
rates defined in CiA 303 version 1.8.0. For performance details,
refer to the PACSystems RX3i CANopen Master Module User's
Manual, GFK-2831.
Network Termination
A 120 ohm termination resistor is required at
the each end of the bus. Where termination is
required, you must use a bus terminal with
built-in selectable termination.
GFK-2837 PACSystems* RX3i CANopen Master Module Quick Start
CAN_L (pin 2)
CAN_H (pin 7)
CAN GND (pin 3)
CAN_L
CAN_H
9