Replacing A Dsic - HP FlexNetwork MSR3064 Installation Manual

Figure 68 Pulling a SIC out
Figure 69 Installing a filler panel

Replacing a DSIC

CAUTION:
DSIC interface modules are not hot swappable. Make sure the router is powered off before installing
a DSIC.
To replace a DSIC:
Completely loosen the captive screws of the DSIC.
1.
Gently pull the DSIC out along the slide rails.
2.
If you need to install SIC or DSIC interface modules, see "Installing the router" for the
installation procedure.
To install filler panels, proceed to steps 3 and 4.
Gently push the slot divider into the DSIC slot along the slide rails and tighten the screws.
3.
Install filler panels and tighten the screws.
4.
50