When Using Too Much Electricity - Panasonic 1M Operation Manuals

When Using Too Much Electricity

●Nothing is displayed if you are using a distribution board without over
Note
current alarm device.
●Use the system after confirming that each device is properly installed.
1
The message lights in red and the
power usage indicator flashes
The figure shows an example where a
household distribution panel with an over
current alarm device (data output)
●If you are using a distribution panel without
Note
level meter, the message lights up in red.
●For information on screen display and call
messages, refer to "LCD display and call
messages". (
2
The alarm message "(beep sound)
Too much electricity is being used"
is output from the speakers of the
base unit and extension speakers
The message is displayed for about
1 minute.
Note ●While the power usage is 110% or more, the
screen display does not turn off.
●It is also possible to turn off the screen.
(
3
If the electricity usage
becomes 100% or below (or
90% or below), the call
message automatically stops
How to stop the call message
Press the Alarm Stop button.
The message stop once but it will be repeated
Note
until the electricity usage becomes 100% or less
(or 90% or less).
Measures taken when a call is made
Reduce the electricity usage.
To change the contracted demand, it
Installer
Setting
is necessary to change the
distribution panel setting.
Consult with the administrating
company.
88
Page 89)
Page 75)
"Be-Be-Beep",
Too much electricity
is being used.
Alarm Stop button
非常
EMERG.
復旧/警報音停止
RESET/STOP ALARM
火災
確認
FIRE CONFIRM
メニュー
MENU
終了
OFF
電源
Gas Not Home Alarm Lock
GAS NOTHOME SET OPEN
POWER
解錠
UNLOCK
Message display
通話
TALK
lights in red
20
The electricity
usage indicator
flashes.