Siemens SIMATIC S5 Manual page 5

Quick access
Standards
Training courses
Queries
ET 200 Distributed I/O System
EWA 4NEB 780 6000-02a
A number of features in this manual will help you to obtain quick access to
the information you require:
At the start of the manual, you will find a general table of contents, plus a
list of all the illustrations and a list of all the tables in the manual.
On each page throughout the manual, the bold-face headings on the left
summarize the contents of the individual passages.
The Appendices are followed by a Glossary containing definitions of the
important terms used in the manual.
The manual closes with an index. The index is in alphabetical order and
you can use it to find information on the topic of your choice.
The IM 308-C master interface and the DP master interface of the S5-95U
are based on DIN standard 19245, Part 1, and DIN E 19245, Part 3.
The KO-ET 200 workshop is an ideal introductory course for users wanting
to familiarize themselves with the ET 200 distributed I/O system.
If you would like more information, contact your regional Training Center or
us at the following address:
Product Marketing for SIMATIC, SINEC and COROS
AUT 951
Postfach 4848
D-90327 Nuremberg
Tel: +49 911 895-3154
Fax: +49 911 895-5021
If you have any questions on the ET 200 distributed I/O system, contact:
Hotline SIMATIC
Erlangen
Tel.: +49 9131/7-43344
If you have any questions or suggestions relating to this manual, please
complete the suggestions sheet and return it to us. You will find the
suggestions sheet inside the rear cover of the manual.
Introduction
v