Panasonic AFPE224300 User Manual page 17

⑨Data display (Upper section)
N and S modes
- Display the data registered using the F180 (SCR) command.
- Display the data in red, green, or orange.
R mode
- Displays the address in the memory area in green.
I mode
- Displays the external input monitor in green.
⑩Data display (Lower section)
N and S modes
- Display the data registered using the F180 (SCR) command.
- Blink when the numerical value is changed.
- Display the data in red, green, or orange.
R mode
- Displays the data in the memory area in green.
I mode
- Displays the external output monitor in green.
⑪Setting display
Indications (e.g.●, ºF, ºC, h, m, s, SV, and PV) and dot between the digits can be displayed individually
by the ladder program.
⑫Mode switch (RUN/PROG.)
Changes the mode of the FP-e unit to RUN or PROG. Modes can also be changed from the
programming tool.
When performing remote switching from the programming tool, the position of the mode switch and the
actual mode of operation may differ.
Verify the mode with the RUN/PROG. display on the front.
When power is supplied, the mode displayed is activated.
⑬Tool port (RS232C)
Used to connect a programming tool.
A commercial mini-DIN 5-pin connector is used for the tool port on the control unit.
*The followings are default settings. Use the system register to change the settings.
Baud rate---------------------------9600bps
Character bit length--------------8 bit
Parity check------------------------Odd parity
Stop bit------------------------------1 bit
⑭Power supply/COM. port connector
⑮Input connector
⑯Output connector
⑰Battery cover
Note: Colors in the display section
④ to ⑦ and ⑪: green
⑨ and ⑩: red, green, or orange (N and S modes), green (R and I modes)
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Pin No. Name
1 Signal ground
2 Send data
3 Receive data
4 (Not used)
5 +5V
⑧: red
Abbr. Signal direction
SG -
SD Unit → External device
RD Unit ← External device
- -
+5V Unit → External device
2-3