Table of Contents
Advertisement
–
Using set command:
racadm set iDRAC.EmailAlert.CustomMsg.[index] [custom-message]
where [index] is the email destination index and[custom-message] is the custom message.
4.
To test the configured email alert, if required:
racadm testemail -i [index]
where [index] is the email destination index to test.
For more information, see the
support/manuals.
Configuring SMTP Email Server Address Settings
You must configure the SMTP server address for email alerts to be sent to specified destinations.
Configuring SMTP Email Server Address Settings Using iDRAC7 Web Interface
To configure the SMTP server address:
1.
In iDRAC7 Web interface, go to Overview → Server → Alerts → SNMP and E-mail Settings.
2.
Enter the valid IP address or fully qualified domain name (FQDN) of the SMTP server to be used in the configuration.
3.
Select the Enable Authentication option and then provide the user name and password (of a user who has access
to SMTP server).
4.
Enter the SMTP port number.
For more information about the fields, see the
5.
Click Apply.
The SMTP settings are configured.
Configuring SMTP Email Server Address Settings Using RACADM
To configure the SMTP email server, use one of the following:
•
Using set command:
racadm set iDRAC.RemoteHosts.SMTPServerIPAddress <SMTP E-mail Server IP
Address>
•
Using config command:
racadm config -g cfgRemoteHosts -o cfgRhostsSmtpServerIpAddr <SMTP E-mail
Server IP Address>
Configuring WS Eventing
The WS Eventing protocol is used for a client service (subscriber) to register interest (subscription) with a server (event
source) for receiving messages containing the server events (notifications or event messages). Clients interested in
receiving the WS Eventing messages can subscribe with iDRAC and receive Lifecycle Controller job related events.
The steps required to configure WS eventing feature to receive WS Eventing messages for changes related to Lifecycle
Controller jobs are described in the Web service Eventing Support for iDRAC7 1.30.30 specification document. In addition
to this specification, see the DSP0226 (DMTF WS Management Specification), Section 10 Notifications (Eventing)
document for the complete information on the WS Eventing protocol. The Lifecycle Controller related jobs are described
in the DCIM Job Control Profile document.
Alerts Message IDs
The following table provides the list of message IDs that are displayed for the alerts.
158
RACADM Command Line Reference Guide for iDRAC7 and CMC available at dell.com/
iDRAC7 Online Help .
Advertisement
Table of Contents
Troubleshooting
