Controlled Round Corner (G50) - Fagor 8055 M Programming Manual

P r o gr a m m i ng m a n u a l
7.3.3

Controlled round corner (G50)

When working in G50 (controlled round corner); once the theoretical interpolation of the current
block has concluded, the CNC waits for the axis to enter the area defined by machine parameter
"INPOSW2" and it then starts executing the following block of the program.
Function G50 assures that the difference between the theoretical and actual paths stays smaller
than what was set by machine parameter "INPOSW2".
On the other hand, when working in G05, the difference between the theoretical and real profiles
depends on the programmed feedrate value "F". The higher the feedrate, the greater the difference
between both profiles.
Function G50 is modal and incompatible with G07, G05 and G51.
On power-up, after executing M02, M30 or after EMERGENCY or RESET, the CNC assumes code
G05 or G07 depending on how the general machine parameter "ICORNER" is set.
G91 G01 G50 Y70 F100
X90
7.
CNC 8055
CNC 8055i
·M· & ·EN· M
ODELS
S : V02.2
OFT X
·115·