Cover Removal; Conduit Plate; Wiring Connections; Option Modules - ABB ACS 601 Hardware Manual

Chapter 3 – Electrical Installation

Cover Removal

Conduit Plate

Wiring Connections

Option Modules

Cover Replacement

Figure 3-1 Frames R2 and R3: Removal of the cover
3-6 ACx=ACS/ACC/ACP
Remove the cover as illustrated in Figure 3-1 on page 3-6 (Frames R2
and R3), Figure 3-2 on page 3-7 (Frames R4 to R6), or Figure 3-3 on
page 3-7 (Frame R7).
Attach conduits to the conduit entry plate at the bottom of the drive.
Knockout sizes and locations are shown on pages B-9 and B-10 in
Appendix B. Terminal locations are shown on the dimensioned
drawings in Appendix A. Select locations for input power, motor, brake
resistor and control wiring according to terminal locations and size
requirements.
Connect the input power, motor, brake resistor and ground wires first
and then connect the control wiring. Refer to Figure 3-4 on page 3-8 for
the recommended wiring configuration. See Appendix B - ACS 601
Dimensional Drawings to locate the terminals on each ACS 601 type.
See Appendix A page A-7 and A-8 for control connection details. Refer
to the ACx 600 Firmware Manual for control I/O programming
information.
General installation instructions are provided on page 3-9. For specific
instructions, refer to the Installation and Start-Up Guide for the option
module.
Replace the cover as shown in Figure 3-6 on page 3-9.
1. Undo the two screws at the
lower front edge of the unit.
2. Lift the lower edge of the cover
to gain access to board A6.
Disconnect the cable from
connector X2.
3. Remove the cover.
4. After connecting the input
power, motor and control
cables, replace the front cover
as shown in Figure 3-6 on page
3-9.)
ACS/ACC/ACP 601 Drives