Using Cli - Nokia IP40 User Manual

5
Connecting to the Internet with Nokia IP40 Security Platform
4. Click Apply.
Dialup is configured.

Using CLI

To configure the dial-up by using the command line interface, log in through the console port.
Dial-up mode can be enabled by using the following options available in CLI:
disable—WAN connection is established regardless of any interesting traffic.
immediate—WAN connection is established only when no other higher priority connection
(primary) exists, regardless of any interesting traffic. This connection becomes inactive
when primary becomes active.
Note
Any traffic that goes to the Internet through LAN is called interesting traffic
activity—WAN connection is established only when interesting traffic is initiated from
internal network to WAN and when no other higher priority connection (primary) exists.
The dialup connection terminates if another higher priority connection becomes active or if
there is no traffic for 1 minute.
Note
Dial-up connection option (always on, demand dialing) and other parameters (number,
username, password, and so on) can be configured by using CLI.
Use the following commands to configure the dialup profile:
set interface wan mode dialup connectondemand <disable |immediate |
activity>
90 Nokia IP40 Security Platform User's Guide v2.0