Cable Shield; Signal Part; Motor - ABB EBN853 Operating Instructions Manual

Electrical connection
Pos: 12.4 /Überschriften/1.1/1-spaltig/J - L/Kabelschirm @ 10\mod_1181823716656_3101.doc @ 106187
5.1

Cable shield

Pos: 12.5 /Überschriften/1.1.1/1-spaltig/Signalteil @ 10\mod_1182501083765_3101.doc @ 108573
5.1.1

Signal part

Pos: 12.6 /Elektrischer Anschluss/Aktorik/Antriebe/Allgemein/Kabelschirm Anschluss @ 10\mod_1181823021906_3101.doc @ 106144
Fig. 9: Fitting the shield
1. Remove approx. 2 cm of cable sheathing (3) from the end of the cable.
2. Separate the shield and peel it back to its inner sheathing (4).
3. Push the cable through the cable gland and fasten with clamp (1).
4. Make sure that the shielding is touching the clamp and the electronic unit housing (2).
Pos: 12.7 /Überschriften/1.1.1/1-spaltig/Motor @ 10\mod_1182501159359_3101.doc @ 108596
5.1.2

Motor

Pos: 12.8 /Elektrischer Anschluss/Aktorik/Antriebe/Allgemein/Kabelschirm Motor @ 10\mod_1182501238328_3101.doc @ 108619
The cable shield must be connected to the motor in a proper manner.
Pos: 12.9 /======= Seitenumbruch ======== @ 0\mod_1126532365768_3101.doc @ 3830
18
1
3
2
EBN853, EBN861 (Contrac)
2
1
4
3
42/68-830-EN
M00307