Table of Contents
Advertisement
PC CONNECTION
The dash cam has two available modes when connecting to a computer, these are:
Mass Storage Mode (Windows and Mac)
This mode is used to view, edit and share recordings using NEXTBASE Replay 3 playback software on
your computer.
Note:
- Mass Storage mode is 'read-only', this means that content on the SD card can only be read, not
updated or erased.
Update Mode (Windows and Mac)
This is used to Update the firmware on your Dash Cam, using NEXTBASE Replay 3.
Please see details within the NEXTBASE Replay 3 Playback software for more information.
Note:
- Update mode is 'read+write', this means that content on the SD card can be updated and erased.
This in turn lets NEXTBASE Replay 3 write the new firmware to the SD card, allowing the automatic
update to take place.
Connecting the Dash Cam to your computer
The USB socket '
' is located on the left had side of the Dash Cam, underneath the removable side
cover. The side cover may or may not be screwed down, depending on how you have chosen to
setup the Dash Cam.
Once the side cover has been removed, connect the supplied USB cable to the Dash Cam and then to
your computer.
Do NOT connect the USB cable to the Powered Mount.
Once connected the Dash Cam will power on and automatically enter Mass Storage mode, this can be
identified by the Protect Button flashing red.
To connect the Dash Cam in Update mode, press and hold the Protect button during connection.
of the USB cable. Release the button once the Wi-Fi button flashes blue.
Note:
- ALWAYS turn off the Dash Cam before disconnecting from your computer.
45
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 380GW and is the answer not in the manual?
Questions and answers
when I press the blue connect button it does not flash and I **** unable to connect to my phone
If the blue Wi-Fi button on the NextBase 380GW is not flashing, it means the camera is not in Wi-Fi mode. To connect to your phone, press the Wi-Fi button until it starts flashing. If the button remains solid blue, the camera is already connected to a mobile phone. If you still experience issues, try resetting the camera and reconnecting from scratch.
This answer is automatically generated
Do you need a special tool to remove side cover to access stop recording button 380GW As it doesn't seem to move very easily and I don't want to cause damage to the outer casing
No, a special tool is not needed. The side cover can be removed using the fingernail slot.
This answer is automatically generated