Basic Setup - ABB ScreenMaster RVG200 Manual

S C R E E N M A S T E R R V G 2 0 0 / PA P E R L E S S R E C O R D E R | C I/ R V G 2 0 0/0 0 1 - E N R E V. A

6 Basic setup

Perform the following steps, in sequence, when setting up the
recorder for first-time use – for detailed configuration routines
refer to the Operating instructions (OI/RVG200-EN).
Start-up
1 Locate and mount the recorder as described in Sections
and .
2
2 Make electrical and signal connections as described in
Section 3 .
3 Power-up the recorder.
IMPORTANT (NOTE)
At power-up, a start-up screen is displayed while a
self-test sequence is performed. An operator view
is displayed when the self-test sequence is
complete and the recorder is ready for operation.
4 Proceed to the next step to set the date and time.
Set the date and time
1 Press the Home icon (
display page 1 of the Operator menus.
2 Press the Configuration icon (
Operator page.
3 Press and at the Operator 1 – Password (0..9999) page
press again (passwords are not set at first-time use).
The Operator 1 Edit / Open / New configuration page is
displayed.
4 Press the Edit Configuration icon
page to display the System Configuration page and press
the Common icon to display the Common Configuration
level menus.
5 Press the tab and at the Date and time field, press the
Time
icon to display the Date and Time dialog.
Enter the required information in each field, pressing
accept the content and return to the Date and Time dialog.
6 When all fields have been set, press
Common Configuration level
Setup Groups and Channel allocation
1 Press the tab and at the Number of Groups field, press
Setup
and enter the number of Groups required.
Press to return to the Common Configuration
level.
2 At the Channel Allocation field, press
Group Configuration dialog. Select the channel(s) to be
assigned to each group. When allocation is complete, press
to return to the Common Configuration
) from any Operator or Log view to
) to display the Select
at the Operator 1(4)
to return to the
menu options.
Time
to display the
Setup
Set up the archive files
1 Press the
Archive
2 Press the
configure Archive parameters – press
content at each field.
1
3 When all fields have been configured, press
the I/O Groups 1(6) page then
Configuration page.
4 Press
return to the System Configuration page.
Set the sample rate
1 At the System Configuration page, press the Groups icon
to display the I/O Groups 1 (6) page.
2 Press the icon associated with the required Group (for
example
3 Press the
each field to enter and configure Recording parameters –
press
Select Operator views and Menu enables
1 At the Group 1 (6) dialog, select the view(s) required by
pressing the
associated fields.
2 Press the
configure view parameters (Chart / Indicator / Bar) and
Menu enables for each view – press
content at each field.
3 Proceed to the next section to set up the archive files.
to
Setup
level.
tab to display the associated fields.
icon associated with each field to enter and
to return to the Common
to exit the Common Configuration level and
) to display the Group 1 (6) dialog.
tab and then the
Recording
to accept the content at each field.
/ / tabs to display the
Chart Bar
Indicator
icon associated with each field to enter and
13
to accept the
to return to
icon associated with
to accept the