Rear Axle (For 2Wd Model) - Suzuki Wagon R Plus RB310 Service Manual

Rear Axle (for 2WD Model)

Installation
Install removed parts in reverse order of removal, noting the fol-
lowing points.
1) Place rear axle on floor jack. Then install lateral rod to rear
axle and tighten nut temporarily by hand.
2) Install trailing arm rear bolts (1) (right & left) in proper direc-
tion as shown in figure. Then tighten nuts (2) temporarily by
hand.
A. Vehicle center side
B. Vehicle outside
3) Install coil springs (1) (right & left) on spring seat (2) of rear
axle as shown in figure and then raise rear axle.
NOTE:
When seating coil spring (1), mate spring end with
stepped part (3) of rear axle spring seat as shown.
A. Upper side
"a": Small
"b": Large
4) Tighten shock absorber lower bolts (1) (right & left) tempo-
rarily by hand.
5) Remove floor jack from rear axle.
6) Clean mating surface of rear axle (right & left) with brake
back plate and apply water tight sealant as shown in figure.
"A": Sealant 99000-31090
REAR SUSPENSION 3E-11