Turning On The Server - NEC Express5800 series User Manual

TURNING ON THE SERVER

Turn on the server and follow the on-screen instructions for setup.
IMPORTANT:
Some optional boards require setups with the SETUP utility before
installation. If the server has a PCI board with the PCI-to-PCI
bridge installed, the SETUP utility is enabled to launch. Check on
the board specifications to find out whether it requires
pre-installation setups before actually installing the board.
Some installed optional devices or connected peripheral devices
require setups before proceeding to the next step.
To use the server with no optional devices installed besides the graphic
board, install a desired OS to the server.
15. Make sure all external devices, such as a video display, keyboard, and mouse
(optional) have been connected, and the power cords are connected.
16. Power on the video display and any other external devices.
Make sure that the floppy disk drive contains no floppy disk and the CD-ROM drive
17.
contains no bootable CD-ROM.
Open the front bezel.
18.
Press the POWER switch.
19.
NOTES:
If the power cord is connected to the power control unit such as the
UPS, turn on the power control unit.
Connect the power cord and wait a few seconds before pressing the
POWER switch. The POWER switch does not work in a few
seconds after connecting the power cord due to BMC (Baseboard
Management Controller) firmware start-up.
Before turning on the server:
POWER lamp
POWER switch
Setting Up Your Storage Server 57