NEC Express5800 series User Manual page 42

POST Execution Flow
The following describes the progress of POST in the chronolo gical order.
IMPORTANT:
Do not make key entries or perform mouse operations while POST
is in progress.
Some system configurations may display the message "Press Any
Key" to prompt a key entry. This message is driven by BIOS of an
installed optional board. Make sure to read the manual that comes
with the optional board before any key entry.
Powering on the server, after you installed or removed an optional
PCI board or moved it to another slot, may display the massage that
indicates incorrect board configuration and suspend POST.
In such a case, press F1 to continue POST. Board configuration can
be made using the utility described later.
4. After a few seconds from power-on, POST starts checking the memory. The count
message of the basic and expansion memory appears at top left on the display unit
screen. The memory check may takes a few minutes to complete depending on the
memory size of the NEC express server. Also, it may take approximately one minute
for the screen display to appear after rebooting the server.
5. Some messages appear upon completion of the memory check. These messages
appear to indicate that the system has detected the CPU, keyboard, and mouse.
6. After a few seconds, POST displays the following message prompting you to launch
the BIOS setup utility, SETUP, stored in the system memory of the server. This
message appears at bottom left on the screen.
Press <F2> to enter SETUP, Press <F12> to Network
Launch the BIOS SETUP utility when you need to change the settings to meet the
requirements for the server. As long as the above message is not displayed with an
error message, you don't have to launch the utility. (Ignore the message. POST will
automatically proceed.)
To launch the SETUP utility, press F2 while the above message is displayed. See
Chapter 4 for setup and parameters.
The server automatically restarts POST all over again when you exit the SETUP
utility.
Press F12 to start the operating system from the network drive.
32 System Overview