Physio Control LIFEPAK 20 Manual page 156

All specifications are at 20°C (68°F) unless otherwise stated.
GENERAL
Classification
The LIFEPAK 20e defibrillator/monitor has seven main operating modes:
Manual Mode
AED Mode
Archive Mode
Setup Mode
Service Mode
Inservice Mode
Auto Test
Mode
POWER
AC Powered
Operating Time
A new, fully charged, internal backup battery provides a minimum of the following prior to
shutdown:
Monitoring plus SpO
(minutes)
Defibrillation (360 J
discharges):
Monitoring Plus Pacing
(minutes at 100 mA, 60 ppm)
Plus SpO :
2
Battery Charging Time
Low Battery Indication
LIFEPAK 20e Defibrillator/Monitor Operating Instructions
©2006-2015 Physio-Control, Inc.
Specifications and Performance Characteristics
Defibrillator—Externally powered Class 1 with battery
backup (per IEC 60601-1)
Applied parts—ECG is Type CF patient connection.
Therapy, SpO , and CO
2
connections (per IEC 60601-1).
Therapy with internal electrodes is Type CF patient
connection.
Provides normal operating capability for ALS users
Provides normal operating capability for BLS users
Allows operator to print, edit or delete previous patient
records
Allows operator to configure the instrument
Allows operator to execute device diagnostic tests and
calibrations
Provides simulated waveforms for demonstration
purposes
Provides daily automatic tests of critical circuits
100-120 VAC 50/60 HZ, 220-240 VAC 50/60 HZ. Total
power draw less than 120 Volt-Amperes (VA), or less
than 150 VA with the CodeManagement Module
installed.
--total--
210
2
140
110
Battery charges while defibrillator operates from AC
power. Typical battery charge time of less than four
hours when defibrillator is powered off and AC power is
applied.
Low battery message in status area and warning tone
sounds.
are Type BF patient
2
--after low battery--
5
3
2
A-1