Setting The Pickup Height Of The Parts - Samsung SM421 Operation Handbook

PART VI. Additional Check Points

5. Setting the pickup height of the parts

- To set the pickup height of the parts, select 'PCB Edit' > 'Feeder Z Pickup' in MMI.
SM421 Operation Handbook
Check Points
You should set the pickup height differently depending
on whether the part is fed by the paper tape reel or by
the emboss tape reel.
Please refer to the figure on the left when you set the
pickup height of the parts.
For detailed information, please refer to "1.3 Reference
plane for the z-axis height of SM tape feeder (p. 1-8)"
in the SM feeder manual.
Example
Paper Type: 1608R -> Z=0.5
Emboss Type: Z=-0.1
54