Figure 6. Connect The Ethernet Cable And Power - Samsung 4G LTE Network Extender 2 User Manual

4
5

Figure 6. Connect the Ethernet Cable and Power

A GPS signal is required for proper operation and E911 service. If a GPS signal is
not acquired after 30 to 60 minutes, please see Chapter 4 Configuring Your
Device.
To see the status of the GPS acquisition, use the Admin website (Local) as shown
in Chapter 3 The Network Extender Admin Website (Local).
6
Verizon 4G LTE Network Extender 2 User Guide v1.1
Copyright © 2017, All Rights Reserved.
Plug one end of the provided Ethernet cable into an available LAN port on
your router and the other end into the LAN port on your Network Extender
(1).
Plug the power supply connector into the DC 12V power port located at the
rear of the Network Extender (2). Insert one end of the power cord into the
power supply and then plug the other end into an available outlet (3).
When the Network Extender is plugged in, the Power/Status LED indicator
will blink blue.
Chapter 2 Network Extender Setup
6