Tools; Test Equipment; Table 15: Checklist For Tools (Installation) - ABB FOX615 Installation & User Manual

4.6

Tools

4.7

Test equipment


FOX615 Installation
Please note:
The ETSI adapter sets contain the following installation material:
• Captive nuts (for the ETSI rack)
• Screws to fix the
− adapters in the ETSI rack (captive nuts)
− subrack, cable tray, fan unit, heat deflection shield etc. (whatever
applies) to the adapters (integrated M6 nuts)
The installation of the subrack and the cable tray requires no special tools.
The checklist below provides an overview of the most important standard
tools required for the installation.
Table 15: Checklist for tools (installation)
Description
Screwdriver for standard slot head
screws
Screwdriver for Phillips head screws
TM
Crimp tool for Mini-Fit HCS
terminals (AWG 18 ... AWG 24)
Parallel action Hand tool for 5556/
5558 Terminals
Wire stripper
Wire cutter
Flat pliers
Connection tool for MDF terminal
strips
Multimeter (Volt, Ampere, Ohm)
Wrist strap (bonding point M4 pre-
ferred)
Bench mats
The installation of the basic equipment (subrack, control unit, power units)
does not require special test equipment. Requirements for test equipment for
Identifica- Quantity
tion
Units
no. 1- 4 1
no. 1- 3 1
crimp 1
69008-0724
1
1
1
1
1
1
1
C H E C K L I S T S
Remark
Units, subrack,
general use
Units, subrack,
general use
Alarm cables
General use
General use
General use
Brand of MDF
General use, to
check the polarity of
the power supply,
etc.
Unit handling
Unit handling
89