Etsi Racks; Cable Tray And Power Supply; Installing The Cable Tray; Figure 22: Cable Tray - ABB FOX615 Installation & User Manual

I N S T A L L A T I O N P R O C E D U R E S
3.3.2

ETSI racks

3.4

Cable tray and power supply

3.4.1

Installing the cable tray

Cable tray installation Proceed as follows:
42
Please note:
The packing of the FOX615 does NOT contain captive nuts.
You need captive nuts for the ETSI rack to fix the ETSI adapters.
Please note:
The ETSI adapter sets contain the appropriate number of captive nuts to fix
the adapters (left and right) in the ETSI rack.
The ETSI adapters contain integrated M6 nuts for the installation of the
FOX615 equipment at the appropriate positions (refer to
For your convenience, you should first install the cable tray with the signal
cables and power supply circuits before you install the FOX subrack.

Figure 22: Cable tray

1. Locate the fixing position of the cable tray in the 19-inch rack or within
the ETSI adapters.
2. Lift the cable tray into position and secure it using four M6 screws.
3. Tighten the screws provisionally.
End of instruction
The numbers on the front of the cable tray correspond to the slot numbers of
the subrack.
Figure 20).

FOX615 Installation