Making Wired Connections; Wan Connection - Hitachi EM-G21 User Manual

4. MAKING WIRED CONNECTIONS

4.1 WAN Connection

Where WAN connection to the Gateway is necessary, follow the procedure below. For
how to operate the WAN side equipment such as edge router, refer to instruction manual
of the WAN side equipment.
1. Turn off power of the Gateway and turn off power of the WAN side equipment.
2. Prepare a LAN cable, either provided by the Gateway or procured according to
Subsection 1.3.3. Connect this LAN cable between the LAN port of the WAN side
equipment and the WAN port in the rear access area of the Gateway until you hear
a click from each port connection. When performing this connection on the
Gateway mounted on the wall, support the Gateway by hand to avoid extra mass.
Note: Equipment layouts and destination connection shown above are for
reference only. These layouts and connection must be made according to actual
environment of the user premise.
3. Turn on power of the WAN side equipment.
4. Turn on power of the Gateway. Ensure that the WAN lamp in the front access area
of the Gateway turns on or blinks in green (see Section 1.2 for the lamp location).
- 13 -