Wireless Connection On Mac Os® X; Connection By Selecting Ssid From List On Mac Os® X - Hitachi EM-G21 User Manual

5.5 Wireless Connection on Mac OS® X
To connect the user PC running Mac OS® X to the Gateway via wireless LAN, you may
follow either of the procedures below.
 Select SSID from list (Subsection 5.5.1)
 Directly type SSID (Subsection 5.5.2)
Of these, only the latter is available if ESSID Stealth is enabled on the target SSID.
5.5.1 Connection by Selecting SSID from List on Mac OS® X
1. If you have not turned on the Gateway and/or the user PC, first start up the Gateway
and then start up the user PC.
2. Disconnect the LAN cable if connected between the user PC and the Gateway.
3. On the user PC, click AirPort icon in the upper right menu bar and select Turn
AirPort On in the menu.
Note: If Turn AirPort On is not available in the menu and Turn AirPort Off is
shown instead, first select Turn AirPort Off in the menu and then select Turn
AirPort On in the menu.
4. In the list of SSIDs, select the SSID value you determined in Subsection 5.1.1
(emg21-●●●●●●-1 for SSID-1 and emg21-●●●●●●-2 for SSID-2 where ●●●●●●
depends on the actual unit).
5. In "Password" field, type the Security Encryption Key value you determined in
Subsection 5.1.2. Click OK button.
6. Click AirPort icon in the upper right menu bar and ensure that the specified SSID is
shown in the menu with a check mark.
Note: If you encounter a connection error dialog during the procedure above, entry of a
wrong Security Encryption Key value is suspect. Click OK button in the error dialog and
redo Steps 3 through 6.
- 23 -